SureLok Electrode Technology The innovative, patented, self-locking electrode mechanism eliminates the need for an installation tool and ensures precise electrode and tip alignment. Both the electrode and tip are stationary which results in a highly defined arc and precise cuts. SureLok alignment also means longer tip and electrode life and reduced operation costs.
Total Gas Management The SL100 SV 1Torch introduces a completely new tip technology which eliminated the need for a separate plasma gas distributor. Each tip includes plasma gas ports uniquely tuned to optimize cutting performance at its rated current. Select from 20, 30, 40, 60, 80, 100 or 120 Amp tips to optimize your cutting. The result is Total Gas Management. Precision gas control, longer consumable parts life and better cut performance.
Superior Quality at All Amperages Whether you are fabricating from thick plate or cutting ornamental shapes, the CUTMASTER Automation Series is perfect for the job.
At 120 Amp output, the CUTMASTER A120 produces the BEST CUT on 1/2" (12mm) mild steel plate at 70 IPM (1.86m/min). For those cutting intricate shapes, select low amperage tips for kerf widths less than 0,045" (1.14mm) wide.
Whether you cut plate, HVAC duct work or ornamental shapes, the CUTMASTER Automation Series is right for you.
Start Cartridge High Frequency has been completely eliminated from the plasma system. A patented component called the "Start Cartridge" sits between the tip and electrode. It is normally in contact with the tip, air forces the plunger to compress and separate from the tip, initiating the pilot arc. This unique design allows the pilot arc to start without moving either the tip or electrode, resulting in better parts life, cut performance and reliability.
The start cartridge is the only moving part in the SL100SV torch. Unlike the competitive torches, where the moving part is the torch head. If the moving parts of a competitor's torch fails, you must replace the entire torch head. This is expensive, complicated, and time consuming. If our start cartridge fails, it's economical, simple, and quick to replace. In less than a minute you're back in full production.
Choice of Tip Shielding Choose from two consumable styles:
Extended Tip for cutting thin sheet at low power & narrow kerf.
Shielded Tip for heavier plate piercing and cutting.
Note: Use the Ohmic Clip with Shielded Tip design if ohmic plate sensing is required.
On orders over $200.00. CONUS, Standard Ground Shipping Prices subject to change Some products not kept in stock Last update 16 July 2010
mechanism eliminates the need for an installation tool and ensures precise electrode and tip alignment. Both the electrode and tip are stationary which results in a highly defined arc and precise cuts. SureLok alignment also means longer tip and electrode life and reduced operation costs.
a separate plasma gas distributor. Each tip includes plasma gas ports uniquely tuned to optimize cutting performance at its rated current. Select from 20, 30, 40, 60, 80, 100 or 120 Amp tips to optimize your cutting. The result is Total Gas Management. Precision gas control, longer consumable parts life and better cut performance.
from the plasma system. A patented component called the "Start Cartridge" sits between the tip and electrode. It is normally in contact with the tip, air forces the plunger to compress and separate from the tip, initiating the pilot arc. This unique design allows the pilot arc to start without moving either the tip or electrode, resulting in better parts life, cut performance and reliability.
