Although it weighs no more thatn comparable small plate helmets, the Big J (H-100A) provides welders with 19 square inches of viewing window.   The plate holder is molded into the shell, and a folded neoprene gasket seals both cover and filter plate to prevent entry of light rays.

• 19 square inches of viewing area.
• To prevent entry of harmful rays the plate holder is molded into shell with folded neoprene gasket seals both cover and filter plate.
• Maximum clearance for nose, chin and largest prescription glasses or goggles.
• Meets ANSI Z87.1.
• Maximum clearance for nose, chin and largest prescription glasses or goggles.
• 4-1/2" x 5-1/4"

• Allows welder to inspect work without raising entire helmet.
• Made of heat-resistant, glass fiver-reinforced plastic.
• Welding plate secured in a hinged door actived by coil springs.
• Furnished with a clear polycarbonate inner safety plate for protection when front is raised.
• 2" x 4-1/4".

A compact design especially useful for welding in close quarters.

• Includes 2" x 4-1/4" plate holder.
• H4-A Lift Front.
• Compact design for use in welding in close quarters.
• Meets ANSI Z87.1.

These helmets provide more protection to the throat area, as well as better ventilation.

• Provided extended protection to the throat area.
• Better ventilation.
• Includes 2" x 4-1/4" plate holder.
• H9-A Lift Front.
• Meets ANSI Z87.1.

A lightweight helmet with shell and plate holder molded in a single piece.

• Inclined tip surface of the plate holder helps resist weld spatter.
• 2" x 4-1/4".

Pipe line version of the integral shell design.

• Pipe line version of the integral shell design.
• Includes a modified Adjust-O-Lok headgear with elastic neoprene insert in place of the adjustment knob.
• Shell exterior has a white coating.

A respirator adapted helmet that allows for greater worker convenience, with a bubble front that makes room for mask-type respirators.   (Note: welding fumes are not reduced unless accompanied by the proper respirator).

• Includes plastic lift-front plate holder.
• 2" x 4-1/4"